TonaliSecurity

  T2000

T2000  was conceived after the need of integration of a some modules capable to mutually interact, in order to fulfil the security task of a small house to the most developed complex of buildings wherever distributed on the territory.

Mostly impressive is the option of T2000 to be linked to the TonaliBAS system, integrating its own functions with those offered from a CCTV system, a smoke and gas detection and the access control several devices.

T2000 is made of all the due components requested by a security installation. The main unit is connected to input/output modules through a field bus line.

T2000 is available in two configurations: T2000/128 to connect up to 128 inputs and 32 outputs and  T2000/512 to connect up to 512 inputs and 32 outputs.

Each output can be individually programmed according to the specific automatic/manual operations it is destined to, on a remote supervisor control.

When connected to the supervisor T2000 offers the following performances:

- Trasmission of selected events only

- Global installation can be subdivided in lower level logical smaller installations, each of them independently operating

- Living display to show sensors and events status

- Local and remote full-duplex audio

T2000 Lon is the new instrument (node) based on the LonWorks technology. Fully linkable (wiring and functions) into a LonWorks field bus network, it is particularly suitable to manage the technical parameters of a building (heating, conditioning, lights, elevators and so on). 

Field sensors with Lon interface are connected to the field bus and their addresses are recognised by the main unit thanks to the standards of the LonWorks system. More traditional sensors can be used and connected to an interface module (alarm node) between them and the field bus. The alarm node, which bears the standards of the LonWorks system, exchange information in full security with the main unit.

Main unit can drive up to 32 points which can be then grouped into eight individually programmable areas. These areas can be added or removed.

Every function is submitted to a protection password from the remote main unit.

Each area, with  its own independent alarm memory, can have assigned its points as active or not. Information is available on display or on network from local/remote controllers. Points and areas numbers can be increased by connecting additional nodes T2000 Lon .